Hi,
Need to do current measurement from 3.3V to the load. Current will be either in 0-100uA range or in 0-150mA range. Board has only 3.3V power. Resolution needed is 1uA / 1mA in each range.
Planning to use INA326 with the configuration mentioned in Figure 8 of datasheet http://e2e.ti.com/support/amplifiers/precision_amplifiers/f/14.aspx?pi73417=5 (with 3.3V power Supply). and use an 18 or 24 bit Del Sigma ADC at the o/p of INA326.
Am I using the right device for this application ?
Is there an accurate gain switching method for INA326 using analog switches so that I will get higher voltage o/p in 0 to 100 uA range and hence use a low resolution ADC?
Thanks in advance for the support on this.
Regards,
Anil