Part Number: TPA3255EVM
Other Parts Discussed in Thread: TPA3255
Other Parts Discussed in Thread: TPA3255
Tool/software:
In the TPA3255 users guide under section 3.3 (page 7), for the default setting of BTL 2.0, it mentions AP analog input under each line for speaker or resistive load. For example,
"Connect left channel speaker/power resistor load (4–8 Ω) to TPA3255 EVM positive output terminal to
OUTA (RED) and AP analog input channel A positive terminal."
Is that a mistake?- For a standard stereo setup, the default 2.0 BTL, I should only need 2 speaker cables attached to Out A (left channel +), and Out B (left channel -), and 2 speaker cables attached to Out C (right channel +), and Out D (right channel-), right? Also, those ground terminals between A/B and C/D are used for a different setup?
- Thanks